COMPONENTS
AC Source
DC Source
Thyristor
Gate Pulse
Resistor
Inductor
Ammeter
Voltmeter
Ground
OBSERVATION TABLE
| S.No. | VLrms (V) |
ILrms (A) |
VLavg (V) |
ILavg (A) |
|---|---|---|---|---|
3
5
4
THY1
7
9
8
THY3
11
13
12
THY5
15
16
ILOAD
1
2
AC1
6
GP1
10
GP3
14
GP5
40
41
R
17
18
AC2
44
45
L
42
43
VLOAD
19
20
AC3
48
49
VDC
46
47
E
21
22
VR
31
GP4
35
GP6
39
GP2
23
24
VY
28
30
29
THY4
32
34
33
THY6
36
38
37
THY2
25
26
VB
27
GND
WAVEFORM
- STEP 1: Drag and drop the components in the workspace to create the circuit.
- Nos of required components:
- AC Source – 3, DC Source – 1, Thyristor – 6, Gate Pulse - 6
- Resistor - 1, Inductor - 1, Voltmeter – 5, Ammeter - 1, Ground – 1
- STEP 2: Make the connections as per the instructions given below:
- (a) (01-17, 02-21, 22-27, 02-04, 04-28, 05-06)
- (b) (03-07, 09-10, 08-32, 07-11, 13-14, 12-36)
- (c) (11-15, 18-23, 24-27, 18-08, 17-19, 19-27)
- (d) (20-25, 26-27, 20-12, 30-31, 29-33, 34-35)
- (e) (33-37, 38-39, 37-47, 37-43, 47-49, 48-46)
- (f) (45-46, 44-41, 40-16, 16-42)
- Note: Click on the wire to delete the connection.
- STEP 3: Click on the CHECK button to check the connections.
- Note: Right click on the component to open the dialog box to edit the properties of the component.
- STEP 4: Input the values for all the required components(DC Source (E), Gate Pulse 1, Resistor and Inductor) and the waveform will get plot automatically.
- STEP 5: Now, Click on the ADD button to insert the reading into the observation table.
- STEP 6: Now, you can input different values as per your requirement to get the desired waveform.
- STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.
- STEP 8: Click on the PRINT button to take out the print of the webpage.
- STEP 9: Click on the RESET button to reload the webpage.